Preventative Water Heater Maintenance in 10 Minutes

Posted by on Sep 24, 2014 in Water Heater Repair Fort Lauderdale

Water heater maintenance in 10 minutes? Yes, that’s correct. Water Heater Repair Fort Lauderdale is going to show one how to perform some water heater preventative maintenance. And, that’s the time it will take to complete these two important water heater maintenance tasks; nevertheless, we understand that these will do an exceptional task of assisting with three things:

  • Having the water heater last much longer for it will save on money with operating it.
  • Ensuring ones water heater runs safely is important for we do not desire it to explode in in ones house.
  • And having it run more energy efficiently likewise helps one save one some money.

We are now ready to spend ten minutes once or two times a year to help save some money on energy bills.

Testing the T&P Relief Valve
The T&P Valve, also referred to as the temperature and pressure relief valve, has a vital job. It’s role is to assist to see to it excess pressure inside the water storage tank does not develop, or in even more basic terms, it makes certain that a water heater does not explode. The T&P valve has a lever or little handle. All one has to do is lift it part way then let go of it back. It is supposed to snap back to its closed position quickly. hopefully, a little water is heard going into the drain pipe below the lever that was just raised and perhaps heard some pressure being released also. If none of these things have happened during the test, the valve will have to be changed.

Carry out a Mini Water Heater Tank Flush
Naturally, rust and rust will take place inside the water storage tank due to the chemical reactions taking place with all the elements inside that are needed to heat water. We will not get overly technical right here, however it is simple to assist prevent this process by doing a flush or draining of all or a portion of the water in the tank.

For just a mini flush, position a container under the drain valve below the tank. Open the drain valve and fill the container with water. Drain a minimum of a few gallons of water in all. Let the water sit in the pail for a couple of minutes to settle and analyze if there is much that settles to the bottom of the container. If there is, if the water heater has not been drained for a long period of time (or ever), it would be best to do a complete flush of the tank to get as much of the sediment out as possible. You will want to turn the temperature dial down and may want to let the water cool down for about an hour initially so it is not too hot while draining it. Likewise, it would be easier to attach a hose to the drain valve and let the water go outside rather of utilizing buckets.

If the water looks fairly clean and clear from the tiny test you should be all set. When the water heater has a large amount of sediment inside of it, it can make loud popping noises and it cuts down on its effectiveness too.

Though water heaters are relatively maintenance free and simple to run, at any time one feels the slightest uncomfortable or are unsure of what to do, it is always best to have give Water Heater Repair Fort Lauderdale FL a call to assist with ones regular water heater maintenance.

Here is an infographic that illustrates these steps, and check out our blog more water heater tips and advice.

Water Heater Repair Fort Lauderdale