The Factors of a Water Heater Tank Explosion

Posted by on Jan 22, 2015 in Gas Water Heater Repair Fort Lauderdale, Water Heater Repair Fort Lauderdale, Water Heater Safety

In terms of needing to undertake upkeep on ones water heater, it is a reasonably minimal maintenance device.  Even so, one critical component of it really should be examined routinely.  Water Heater Repair Fort Lauderdale wishes to pass on this safety material concerning ones water heater today.

High temperature if put together with tank deterioration inside of the storage tank may cause an explosion. If the water temperature is under 212 degrees Fahrenheit, one shall be protected from an explosion, though there is a associated risk of scalding at that temperature.  However, if the water temperature is greater than 212 degrees, water becomes into steam, which will enlarge to 1,700 times the space it takes up as water. This is the time an explosion can also occur.Hot Water Heater Repair Fort Lauderdale

Cautionary Indications of a Water Heater Explosion

The leading sign is if one goes to get hot water from a faucet and only steam comes out.  Promptly shut off electric power if one possesses an electric water heater.  If one possesses a gas hot water heater, shut off the gas valve on the water heater.  And then, give us a call to come pinpoint the predicament.

Minimizing Potential Water Heater Dangers

The most critical routine maintenance activity having a water heater is to examine the pressure relief valve, referred to as the T&P valve, on a usual schedule.   This valve helps control the pressure accumulation inside of the water storage tank to reduce a unsafe increase in temperature and overpressure.

Caution!
Remember, the water release out of a T&P valve may be quite hot. If you do not feel safe evaluating the valve contact us.  In addition, undertaking any kind of fixes to the valve really should be performed by a experienced plumbing repair provider.

How to Test the T&P Valve

Clear the place near the overflow pipe and floor drain.
Lift up the test handle for around 5 seconds or until the water runs clean.
Let go of the handle.
If the T&P valve keeps on running with water, raise the handle up and down rapidly to have it reseat itself.  One may need to do this a several times.  IF it has not been tested for a while, it might be difficult to raise it at first.  Avoid using excessive force, although could need to make use of just a little.
If the T&P valve continues to have water coming out, it needs to be changed.

Additional points to watch out for are rust on the stem of the valve.  If there is any water seeping out of the valve stem or out of the drain valve.

Seeking far more hints?  Have a look at Water Heater Repair Fort Lauderdale’s additional articles right here:

Preventative Water Heater Maintenance in 10 Minutes

Fort Lauderdale Water Heater Safety Precautions

From around the Web:

The Aquanta smart water-heater controller promises to slash your energy bill

Home maintenance checklist: Fall